Settings / Follow Mode
These settings control how vessel Follow Mode operates.
When enabled, Follow Mode cause the display screen to follow
the movement of your vessel. You enter this mode by tapping the
arrow in the top-right of the display. Tapping a second time changes
to course-up display. You can exit Follow Mode by tapping
the arrow again or (if Sticky mode is not enabled) by
panning or zooming the display.
If you entered course-up or heading-up mode, you can re-orient the
display to true-north-up by pressing on the orange compass rose ("N")
in the top-left of the navigation display.
Use Offset in Follow Mode
: When enabled and in Follow Mode, the vessel is offset backwards so that a larger part of the display area is in front of it. Otherwise, the vessel is in the center of the display.
Follow Mode is Sticky
: When disabled, any manual movement of the display (panning, zooming, rotation) immediately disables Follow mode. When enabled, Follow mode remains enabled after you pan/zoom/rotate the display, but is temporarily disabled. When you have not adjusted the display for 30 seconds, Follow mode re-centers the display on your vessel.
(Only SEAiq Pilot) : When in offset or heads-up mode, you can choose to orient using the vessel's course (COG) or heading (HDG). Normally these are very similar, but when moving slowly or astern they can be quite different.