Shuttle Pilot

These settings allow use of with the Navicom Dynamics Shuttle Pilot. It allows additional targets to be delivered over your NNMEA feed.

This feature requires activation with your Enterprise Subscription.

Settings

• Enable (Only SEAiq Pilot) : This switch turns on Shuttle Pilot support.
• Talker ID (Only SEAiq Pilot) : This controls the NMEA Talker ID that identifies the remote Shuttle Pilot device.
• Vessel Name (Only SEAiq Pilot) : This is the name to use when referring to the remote vessel.
• Heading Offset (Only SEAiq Pilot) : The heading offset is added to the sensor value to generate the heading to use. The default heading offset is 0° (no change). Negative values correct to Port and positive values correct to Starboard. Normally the desired setting is either 90° or -90°.
• Length (Only SEAiq Pilot) : Manually enter length of the remote vessel.
• Beam (Only SEAiq Pilot) : Manually enter beam of the remote vessel.
• Distance to Bow (Only SEAiq Pilot) : Manually enter distance from bow to antenna for the remote vessel.
• Distance from Centerline (Only SEAiq Pilot) : Manually enter distance from centerline to antenna for the remote vessel.
• Status & Diagnostics : This shows diagnostics describing the current status of remote vessel.